You can get a cheap 10ft crossover cable on Amazon for $5 or you can get crossover adapters, which are a little bit more, but can turn any Ethernet cable into a crossover cable. So just check your cable on both end and make sure it matches the diagram. The only pins that need to be crossed are 1,3 and 2,6. Basically, there are a few different types of crossover cables, but it’s best to get the standard crossover cable where the green and orange pairs are swapped and the brown and blue pairs stay in the same position. The second thing you need to verify is that you actually have a proper crossover cable. If you need more info about static IPs, make sure to read my post on how to assign a static IP address in Windows and Mac. It’s worth noting that you could technically leave the Default Gateway and Preferred DNS server fields blank as you really don’t have to connect to any device outside the local network. Below is how my setup looks for one computer: You can pick which IP address you want to use, but use it on both computers for the default gateway. Lastly, the value for the default gateway should be the same on both machines. If you use an incorrect subnet mask, the connection will not work. If you used the above IP addresses, you should use a subnet mask of 255.255.255.0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |